71M6511/71M6511H
Single-Phase Energy Meter IC
A Maxim Integrated Products Brand
DATA SHEET
NOVEMBER 2010
TMUXOUT Pin: One out of 16 digital or 4 analog signals can be selected to be output on the TMUXOUT pin. The function of
the multiplexer is controlled with the I/O RAM register TMUX (0x2000[3:0]), as shown in Table 58.
TMUX[3:0]
Mode
Function
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
analog
analog
analog
analog
digital
digital
digital
digital
digital
digital
digital
digital
--
digital
digital
digital
DGND
IBIAS
PLL_2.5V
VBIAS
RTM (Real time output from CE)
WDTR_EN (Comparator 1 Output AND V1LT3)
reserved
reserved
RXD (from Optical interface)
MUX_SYNC
CK_10M
CK_MPU
reserved for production test
RTCLK
CE_BUSY
XFER_BUSY
Table 58: TMUX[3:0] Selections
Emulator Port: The emulator port, consisting of the pins E_RST, E_TCLK and E_RXTX provides control of the MPU through
an external in-circuit emulator. The emulator port is compatible with the ADM51 emulators manufactured by Signum Systems.
The signals of the emulator port have weak pull-ups. Adding 1k ? pull-up resistors on the PCB is recommended.
Real-Time Monitor: The RTM output of the CE is available as one of the digital multiplexer options. RTM data is read from the
CE DRAM locations specified by I/O RAM registers RTM0 , RTM1 , RTM2 , and RTM3 after the rise of MUX_SYNC. The RTM can
be enabled and disabled with I/O RAM register RTM_EN . The RTM output is clocked by CKTEST. Each RTM word is clocked
out in 35 cycles and contains a leading flag bit. Figure 13 in the System Timing Section illustrates the RTM output format. RTM
is low when not in use.
SSI Interface: A high-speed serial interface with handshake capability is available to send a contiguous block of CE data to an
external data logger or DSP. The block of data, configurable as to location and size, is sent starting 1 cycle of 32kHz before
each CE code pass begins. If the block of data is big enough that transmission has not completed when the code pass begins,
it will complete during the CE code pass with no timing impact to the CE or the serial data. In this case, care must be taken
that the transmitted data is not modified unexpectedly by the CE. The SSI interface is enabled by the SSI_EN bit and consists
of SCLK, SSDATA, and SFR as outputs and, optionally, SRDY as input. The interface is compatible with 16bit and 32bit
processors. The operation of each pin is as follows:
SCLK is the serial clock. The clock can be 5MHz or 10MHz, as specified by the SSI_10M bit. The SSI_CKGATE bit controls
whether SCLK runs continuously or is gated off when no SSI activity is occurring. If SCLK is gated, it will begin 3 cycles before
SFR rises and will persist 3 cycles after the last data bit is output.
The pins used for the SSI are multiplexed with the LCD segment outputs, as shown in Table 59. Thus, the LCD should be
disabled when the SSI is in use.
Page: 45 of 98
? 2005–2010 Teridian Semiconductor Corporation
V2.7
相关PDF资料
71M6513H-IGT/F IC ENERGY METER 3PH 100-LQFP
71M6515H-IGT/F IC ENERGY METER AFE 3PH 64-LQFP
71M6521BE-IGTR/F IC ENERGY METER 8K FLASH 64-LQFP
71M6533G-IGTR/F IC ENERGY METER 3PH 100LQFP
71M6543F-IGT/F IC ENERGY METERING
71M6545-IGT/F IC ENERGY METERING
720-10007-00300 CBL D-SUB 9PIN FMAL-25PIN FML 3M
720-10010-00025 CBL DSUB 9PIN FML-25PIN MAL .25M
相关代理商/技术参数
71M6511-IGT 制造商:TERIDIAN 制造商全称:TERIDIAN 功能描述:Single-Phase Energy Meter IC
71M6511-IGT/F 功能描述:计量片上系统 - SoC Highly Integrated SoC w/MCU Core RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel
71M6511-IGT/F1 功能描述:计量片上系统 - SoC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel
71M6511-IGTR 制造商:TERIDIAN 制造商全称:TERIDIAN 功能描述:Single-Phase Energy Meter IC
71M6511-IGTR/F 功能描述:计量片上系统 - SoC Highly Integrated SoC w/MCU Core RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel
71M6511-IGTR/F1 功能描述:计量片上系统 - SoC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel
71M6512-DB 制造商:Maxim Integrated Products 功能描述:Development Boards & Kits - 8051 71M6512 Demo Brd
71M6512-IM/F 制造商:Maxim Integrated Products 功能描述:Metering Systems on a Chip - SoC Residential Meter Extended Io